Fitting our Faux Leather seat frame covers

Please Make Sure you follow these instructions exactly to ensure your covers are fitted correctly and not damaged. Please be aware that some covers ARE NOT EASY to fit but if you take the time and effort to get them fitted correctly they will look as good if not better than your original handles. With some curved bars it is not possible for us to shape the cover right to the very end of the bar you may fins a slight variance of a couple of mm but this shouldn't be too noticeable. If you have any problems please contact us using our contact us page located bottom left of this page.

Bottom half cover with 1 zip
Show More

Bottom Half seat frame with 1 Zipper

Bottom Half seat frame with 2 Zippers

Step 1

Line the cover up with one end and zip up a few CM.

Step 2

Line the cover up with the opposite side. You will notice that the cover appears too short, this is because you need to stretch your cover over to the end to reduce wrinkles on the zip side. If you're struggling to get your cover to meet the end try heating it up with a hairdryer as this makes it stretch easier.

Step 3

Once in place again Zip up you zip a few cm to hold in place.

Step 4

Once the cover is in place simply zip carefully around both sides. If you're struggling around the corners it helps to pinch the zip together as you go.

Smaller side pieces for Cameleon 1/2 and some Cameleon 3's ONLY

Step 1

If you have straps attached to your bar pull these up out the way. Line up the cover with the top of the foam.

Step 2

Zip the cover up to the end.

Step 3

Carefully manipulate the strap back over the cover.

Step 4

Repeat these step on the opposite side.

Follow
  • Grey Facebook Icon
  • Grey Instagram Icon
  • Grey Twitter Icon

Please read our terms & conditions

Site design by sammydevelop